G) Clog Removal - Panasonic MC-UL426 Operating Instructions Manual

G) CLOG REMOVAL

If the vacuum cleaner does not seem to have adequate suction, first check if the dust bin
is full or if a filter is clogged. Refer to EMPTYING DUST BIN (pages 23-24), PRE-FILTER
CLEANING (pages 25-26), PRIMARY FILTER CLEANING (pages 26-27), and HEPA
MEDIA EXHAUST FILTER REPLACEMENT (page 28).
1 1
Suction
Inlet
Nozzle
Hose
Turn off and unplug the vacuum cleaner.
Remove dust bin and check for clogs.
Check the hose inlet area.
Visually inspect the tools, the hose,
and the nozzle hose area into which
the hose is connected.
Hose Inlet
- 33 -
1 2
Check the suction inlet area.
Remove any visible clog.
Plug in the vacuum cleaner and turn on.
Stretch the hose to maximum length and
then allow the hose to return to its storage
length.
If the dust bin and filter areas and the
hose areas are free of clogs, check the
nozzle area.
Hose