To Check Programmes; Starting And Canceling Programmes; To Clear A Timer Recording Programme - Panasonic DMR-E30 Operating Instructions Manual

To check programmes

Press [PROG/CHECK] (13).
The Timer Programme List screen appears.
TIMER
RECORDING
No. Name Date Start Stop
01 BBC 1 16/ 7 TUE 1:19 1:22
W 16/ 7 TUE 1:20
02 BBC 1 2:20
A
F
03 BBC 1 24/ 7 WED 8:00 9:00
04 BBC 1 24/ 7 WED 9:00 10:00
X
05 BBC 1 24/ 7 WED 10:00 11:00
New Timer Programme
SELECT
CANCEL
ENTER
RETURN
Icon explanations ( A )
This programme is currently recording.
¥
W
The programme is overlap with another programme.
F The disc was full or the maximum number of programmes or
scenes was reached so the programme failed to record.
The television programme was copy-guarded so the
programme failed to record.
X The programme failed to record for some other reason.
Disc space
OK: Displayed if the recording can fit in the remaining
space on the disc. However, when the programme
becomes longer than scheduled during the
recording by setting "PDC" to "ON", the
programme may not be recorded until its end.
# (Date):
For recordings made daily or weekly, the display
will show until when recordings can be made
based on the time remaining on the disc.
!: Displayed if the disc is not inserted in the unit or is
write-protected (pages 37, 73) or there is not
enough memory capacity left on the disc.
ª To change the programme
(page 33)
ª To exit from the Timer Programme List screen
Press [PROG/CHECK] (13) or [RETURN] (23). (The television is
shown.)
For your reference
≥ Programmes that failed to record are deleted from the list at 4
a.m. the day after tomorrow.
Remain
1:58 SP
1:19:00 16.7 TUE
Disc
Mode
PDC
space
SP OFF OK
SP OFF OK
SP OFF OK
SP OFF OK
SP OFF OK

Starting and canceling programmes

ª To put the unit on recording standby
Press [Á, TIMER] (12).
The unit turns off and " Á " lights on the unit's display.
Note
≥ The unit cannot go to timer recording standby if the disc is
protected (pages 37, 73) or full (" Á " flashes). Check the disc
carefully.
ª To release the unit from recording standby
If you want to record something else before the programme start
time, for example:
Press [Á, TIMER] (12).
The unit turns on and " Á " goes out.
≥ Be sure to press [ Á , TIMER] (12) before the programme start
time to put the unit on recording standby. The programme only
works if " Á " is on.
ª To stop recording while a programme is working
Press [Á, TIMER] (12).

To clear a timer recording programme

Press [CANCEL] (5) or [ERASE] (30) while the
programme's Timer Programme Correction screen is
being shown.
(Alternatively, use [3, 4] (10) to select the programme
in the Timer Programme List screen and press
[CANCEL] (5) or [ERASE] (30).)
≥ You can not delete programmes that are currently recording.
34
Timer recording (continued)