Removing And Refitting The Wire Shelves Or Left And Right Hand Side Rails; Unhooking And Hanging The Oven Door - Siemens HB22AR..1 SERIES Instruction Manual

Removing and refitting the wire shelves or left
and right hand side rails
The wire shelves or left and right hand side rails can be
removed for cleaning. The oven must be cold.
Removing the wire shelves or rails
Lift the wire shelf or rail from the front
1.
and release it (figure A).
2.
Then pull the wire shelf or rail completely out and remove it
3.
(figure B).
$
Clean the wire shelves or rails with washing-up liquid and a
sponge. The use of a brush is recommended for stubborn
stains.
Install the wire shelves or rails
First insert the shelf or the rail in the rear groove by pushing it
1.
back slightly (figure A)
then insert it in the front groove (figure B).
2.
$
Wire shelves or rails can be adjusted on the left and right hand
side. Their curvature should always be face down.

Unhooking and hanging the oven door

The front panel can be unhooked to help remove the oven door
and clean the glass panels.
The oven door hinges are fitted with a locking lever. The door
cannot be unhooked if the locking lever is closed (figure A).
Once the locking lever has been opened to unhook the door
(figure B), the hinges will be locked in position. This prevents
the door from suddenly closing.
$
ã=
Risk of injuries.!
The hinges may close suddenly if they are not locked in
position by the lever. Note that the locking levers are always
closed, apart from when unhooking the door, when the levers
must be open.
10
%
%
%
Unhooking the door
Fully open the oven door.
1.
Remove both locking levers located on the right and left hand
2.
sides (figure A).
Fully close the oven door as far as possible (figure B). Grip
3.
the left and right hand sides of the door with both hands.
Close the door slightly more and remove it.
$
Hanging the door
Rehang the door by following the same steps but in reverse
order.
When refitting the door, check that both hinges are
1.
positioned exactly inside their respective openings (picture
A).
The bottom groove of the hinges must fit snugly on both
2.
sides.
$
The door may be left crooked if the hinges are not mounted
properly.
Reclose the attachment levers (picture C). Close the oven
3.
door.
&
ã=
Risk of injuries.!
Do not touch the hinges; the door might accidentally fall or a
hinge might suddenly close. Notify the Technical Assistance
Service.
%
%