Light; Removing And Refitting The Wire Shelves Or Left And Right Hand Side Rails; Unhooking And Hanging The Oven Door - Siemens HB34A Series Instruction Manual

Zone Cleaning products
Display Glass cleaning products:
Clean using a soft cloth. Do not use
alcohol, vinegar or other abrasive or
acidic cleaning products.
Glass panels on oven Glass cleaning products:
door Clean using a soft cloth. Do not use a
glass scraper.
Oven interior Hot water with a little soap or water and
vinegar:
Clean with a dishcloth.
If very dirty, use a stainless steel
scourer or special oven cleaning prod-
ucts. These must only be used when
the oven interior is cold.
Glass cover for the Hot water and a little soap:
oven light Clean with a dishcloth.
Seal (do not remove) Hot water and a little soap:
Clean with a dishcloth. Do not rub.
Wire shelves or rails Hot water and a little soap:
Soak and clean using a dishcloth or
brush.
Sliding guides Hot water and a little soap:
Clean with a dishcloth or a brush. Do
not leave this to soak or wash in a dish-
washer.
Accessories Hot water and a little soap:
Soak and clean using a dishcloth or
brush.

Light

The oven light can be turned on manually to facilitate cleaning.
Connecting the oven bulb
Turn the function control knob to the
The light will come on.
Turning the oven light off
Turn the function control knob to the
Removing and refitting the wire shelves or left
and right hand side rails
The wire shelves or left and right hand side rails can be
removed for cleaning. The oven must be cold.
Release the guides or rails
Lift the front of the guide or rail and release it (figure A).
1.
Then pull the guide or rail forwards completely and remove it
2.
(figure B).
Clean the guides or rails with detergents and a sponge. The
use of a brush is recommended for stubborn stains.
12
position.
\
Û position.
Install the wire shelves or rails
First insert the shelf or the rail in the rear groove by pushing it
1.
back slightly (figure A)
then insert it in the front groove (figure B).
2.
Wire shelves or rails can be adjusted on the left and right hand
side. Their curvature should always be face down.

Unhooking and hanging the oven door

The front panel can be unhooked to help remove the oven door
and clean the glass panels.
The oven door hinges are fitted with a locking lever. The door
cannot be unhooked if the locking lever is closed (figure A).
Once the locking lever has been opened to unhook the door
(figure B), the hinges will be locked in position. This prevents
the door from suddenly closing.
:
Risk of injuries.!
The hinges may close suddenly if they are not locked in
position by the lever. Note that the locking levers are always
closed, apart from when unhooking the door, when the levers
must be open.
Unhooking the door
Fully open the oven door.
1.
Remove both locking levers located on the right and left hand
2.
sides (figure A).
Fully close the oven door as far as possible (figure B). Grip
3.
the left and right hand sides of the door with both hands.
Close the door slightly more and remove it.