Table of Contents
Advertisement
1 2 3 4 5 6 7 8 9 10
Cables necessary for connection (commercially available)
Speaker cables (x the number of speakers)
+
+
–
–
Audio pin cable (two for connecting two subwoofers)
Connection diagram
Refer to the following diagram and connect the speakers to the unit.
The unit (rear)
E
1
9
4
6
• When using only one surround back speaker, connect it to the SINGLE jack (L side).
R
2
3
9
5
7
❑ Connecting speaker cables
Speaker cables have two wires. One is for connecting the negative (-) terminal of the
unit and the speaker, and the other is for the positive (+) terminal. If the wires are
colored to prevent confusion, connect the black wire to the negative and the other wire
to the positive terminal.
a Remove approximately 10 mm (3/8") of insulation from the ends of the speaker cable, and
twist the bare wires of the cable firmly together.
b Loosen the speaker terminal.
c Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the
terminal.
d Tighten the terminal.
c
F R
O N
+ (red)
b
T
a a
d
– (black)
Using a banana plug
a Tighten the speaker terminal.
b Insert a banana plug into the end of the terminal.
a
F R
O N
T
Banana plug
b
❑ Connecting the subwoofer (with built-in amplifier)
Use an audio pin cable to connect the subwoofer.
Audio pin cable
PREPARATIONS ➤ Connecting speakers
19
En
Advertisement
Table of Contents
