Quick Guide; Connecting The Devices - Yamaha CL5 Owner's Manual

Quick Guide

Quick Guide
This section explains the general procedures in a mixing
workflow. The example below is based on a system in
which one CL5, one I/O device, an amplifier and speakers
are connected. If there are multiple methods to achieve the
same result, this section introduces the simplest method.
For details on the functions and their parameters, refer to
the Reference Manual.

Connecting the devices

Setting up the Dante network
1.
Press the SETUP button in the touchscreen.
2.
Press the DANTE SETUP button in the SETUP
screen.
3.
In the lower part of the DANTE SETUP screen,
press the SETUP tab.
4.
Set CONSOLE ID to #1, and SECONDARY
PORT to DAISY CHAIN.
NOTE
If you want to change the settings, you must first
disconnect all I/O devices before doing so. If you fail to do
so, communication with the I/O devices will become
impossible.
If you changed the settings, press the APPLY button;
when the confirmation screen appears, click the OK
button.
The button you changed will change from red back to
white; please wait approximately 30 seconds for the
settings to be applied.
40
➩
Owner's Manual
5.
Set BIT to 24, and LATENCY to 0.25.
Connecting I/O devices
1.
Make sure that power to all devices to be
connected is turned off. Then, use an
Ethernet cable to connect the Dante
PRIMARY connector on the CL to the Dante
PRIMARY connector on the I/O device.
2.
Specify the ID of the I/O device.
NOTE
If you plan to use one I/O device, set its ID number to "1."
If you plan to use multiple devices, you must assign a
unique ID number to each device.
3.
Turn on the power to the I/O device, the CL
series, and then the amplifier, in that order.
4.
In the touchscreen, press the SETUP button,
then the DANTE SETUP button, and finally the
DEVICE MOUNT tab.
5.
Check the I/O devices.
NOTE
If you're connecting an I/O device other than the
Rio3224-D, you'll need to mount it.
See the reference manual for details.
6.
Connect mics or instruments to the I/O
device.
Setting the word clock
1.
Press the SETUP button in
the display screen, then
press the WORD
CLOCK/SLOT button.
2.
Select INT 48k or INT
44.1k.
3.
Press the X symbol to close the screen.