Measuring At Multiple Listening Positions (Multi Measure) - Yamaha RX-V3073 Owner's Manual

1 2 3 4 5 6 7 8 9
Automatic speaker setup
SOURCE SOURCE RECEIVER RECEIVER
AV AV
1 1 2 2 3 3 4 4
5 5 6 6 7 7 V-AUX V-AUX
AUDIO AUDIO
1 1 2 2 3 3 4 4
PHONO PHONO MULTI MULTI L L USB USB NET NET
TUNER TUNER [ A ] [ A ] [ B ] [ B ] [ C ] [ C ]
SCENE SCENE
1 1 2 2 3 3 4 4
VOLUME VOLUME
PROGRAM PROGRAM MUTE MUTE
TOP MENU TOP MENU POP-UP/MENU POP-UP/MENU
ON SCREEN ON SCREEN OPTION OPTION
Cursor keys
ENTER
ENTER
RETURN
RETURN DISPLAY DISPLAY
MODE MODE
LIVE LIVE
CLASSICAL CLASSICAL CLASSICAL ENTERTAI T T N ENTERTAIN
CLUB CLUB
PRESET PRESET
MOVIE MOVIE STEREO STEREO STRAIGHT STRAIGHT
TV TV
PURE PURE
INPUT INPUT
DIRECT DIRECT
TV VOL TV VOL TV CH TV CH
MUTE MUTE
4
To save the measurement results, use the cursor
keys (e/r) to select "SAVE" and press ENTER.
The adjusted speaker settings are applied.
• To finish the measurement without saving the result, select "CANCEL".
5
Disconnect the YPAO microphone from the unit.
This completes optimization of the speaker settings.
Caution
• The YPAO microphone is sensitive to heat, so should not be placed anywhere
where it could be exposed to direct sunlight or high temperatures (such as on
top of AV equipment).
Measuring at multiple listening positions
(multi measure)
When "Multi Position" is set to "Yes", follow the procedure below for
measurement.
• Do not stand between the speakers and the YPAO microphone during the
measurement process. It takes about 15 minutes to measure 8 listening positions.
• Move to the corner of the room or leave the room.
• If any error message (such as E-1) or warning message (such as W-1) appears,
see "Error messages" (p.58) or "Warning messages" (p.59).
1
To start the measurement, use the cursor keys to
select "Measure" and press ENTER.
The measurement will start in 10 seconds. Press ENTER
again to start the measurement immediately.
• To cancel the measurement temporarily, press RETURN.
The following screen appears on the TV when the
measurement at the first position finishes.
2
Move the YPAO microphone to the next listening
position and press ENTER.
Repeat Step 2 until measurements at all listening positions
(up to 8) have been taken.
PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO)
54
En