Changing Source Names In The Display Window - Yamaha RX-V2067 Owner's Manual

SOURCE RECEIVER
l
ASETUP
7 Press
menu.
AV
1 2 3 4 4
NOTES
5 6 7 V-AUX
AUDIO • "ERROR" appears in the display window on the
d
1 2 3 4
remote control if you press a button not indicated in
PHONO MULTI USB NET
the respective step, or when you press more than one
DOCK TUNER
[ A ] [ B ]
button simultaneously.
SCENE
e
1 2 3 4
• This remote control can learn approximately 200
functions. However, depending on the signals learned,
"FULL" may appear in the display before you
program 200 functions. In this case, clear unnecessary
programmed functions to make room for further
learning (☞p.
• Learning may not be possible in the following cases:
i
ENTER
– when the batteries in the remote control for this unit
or other components are weak.
– when the remote control is exposed to direct
sunlight.
– when the function to be programmed is continuous
or uncommon.
k
TUN./CH
A
ZONE SETUP
B
again to exit from the setup
119).
Changing source names in the
display window
The name of the control area (input source) that appears
in the display window on the remote control can be
changed.
Press ASETUP.
1
"SETUP" appears in the display window.
iCursor B / C
Press repeatedly to select
2
"RENAME" and press iENTER.
dInput selector eSCENE
3 Press or
the desired control area.
Edit the name of the control area.
4
i Cursor D /
To locate the position to edit, press
i Cursor B /
To select a character, press
iCursor B
Press to change the character in the
iCursor C
following order, or press to go in the
reverse order: A to Z, a to z, 0 to 9, space, symbols (-,
+, /, :).
Controlling the remote control to operate various functions
iENTER
5 Press to set the new name.
"OK" appears in the display window on the remote
control if renaming was successful.
When you want to rename the another control area,
dInput selector
press to select the desired control
iENTER
area and then press
operations of steps 4 to 5.
l RECEIVER A
• Press
to rename the control area for
the receiver.
k A
• Press to rename the control area for the TV
monitor.
e
• Press SCENE key to rename the control area for the
scenes. When rename the control area for the scenes of
to select
B
ZONE
each zone, press
1.
E.
ASETUP
6 Press again to exit from the setup
C.
menu.
NOTE
"ERROR" appears in the display window on the
remote control if you press a button not indicated in
the respective step, or when you press more than one
button simultaneously.
SETUP
and then carry out the
to select a zone before step
116
En