Yamaha HTR-6295 Owner's Manual page 68

Troubleshooting
Problem
No sound is output
from a specific
speaker.
No sound is heard
from the subwoofer.
No sound is heard
from the surround
back speakers.
The audio input
sources cannot be
played in the desired
digital audio signal
format.
Multi-channel
playback is not
available.
64
En
Cause
Output from that speaker is disabled.
The volume of that speaker is set to
minimum in "Speaker Setup" in the
"Setup" menu.
This unit is in the straight decode mode.
Sound may not be output from certain
channels depending on input sources or
sound field programs.
The speaker is malfunction.
"LFE / Bass Out" is set to "Front" and a
Dolby Digital, DTS or AAC signals is
being played.
"LFE / Bass Out" is set to "Subwoofer" or
"Front" and a 2-channel source is being
played.
The source does not contain low
frequency signals.
"Extended Surround" in the Option menu
is set to "Off", or an input signal does not
contain a surround back flag with
"Extended Surround" set to "Auto".
The connected component is not set to
output the desired digital audio signals.
The connected component is set to output
2-ch or PCM signals.
"Audio Output" is set to "Amplifier +
TV".
Remedy
Check the Speaker indicators on the front panel
display. If the corresponding indicator is turned off,
try the following.
1) Change the input source to another one.
2) With the selected sound field program, sound is not
output from that speaker. Select another sound field
program.
3) "None" may have been selected for that speaker on
this unit. Display "Speaker Setup" in the "Setup"
menu and enables output of that speaker.
Display "Speaker Setup" in the "Setup" menu and
adjust the volume (Manual Setup → Speaker Level).
Press QSTRAIGHT (or rSTRAIGHT) to turn
off the straight decode mode.
Try another sound field program.
Check the speaker indicators on the front panel
display. If the corresponding indicator lights up,
connect another speaker and check if sound is output.
If sound is not output, this unit may be malfunction.
Set "LFE / Bass Out" to "Subwoofer" or "Both".
Set "LFE / Bass Out" to "Both".
Set "Extended Surround" other than "Off" or "Auto".
Set the playback component properly referring to its
operating instructions.
Set the playback component properly referring to its
operating instructions.
Set "Audio Output" to "Amplifier".
See
page
6, 24, 27,
46
48
30
27
—
47
47
41
—
—
49