Siemens WD14D366HK Instruction Manual And Installation Instructions page 24

Spinning during drying
Drying result not
satisfactory.
The fabric softener is not
completely flushed in or too
much water remains in the
compartment i.
The laundry is not dried.
No display on the display
panel.
Door cannot be opened.
Emergency release
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to Off and unplug the mains plug from the socket.
– Turn off the tap and call the after-sales service –> page 25.
No fault
The laundry clings to the sides of the
drum after being spun.
Closed tap
Selected drying time too short.
Maximum or minimum load not taken
into account –> page 30.
The fabric softener compartment insert
is not correctly attached or is blocked.
The tap is turned off.
The load is too large.
The drying time is too short.
Power cut.
$ (Rinse hold) has been selected.
The programme is running or the door
is locked for safety reasons.
Power cut.
To release the door mechanically in the event of a power cut:
 turn the programme selector to Off and unplug the mains plug from the
socket.
 open the base panel and drain out the water –> page 21.
 remove the panel.
 pull the emergency release downwards and open the door at the same time.
Before opening the door, make sure that there is no water or hot detergent
solution in the washer dryer.
Under no circumstances open the door with the emergency release while the
drum is still turning.
"Thermo spin", which is for energy-effi-
cient drying, starts after a drying time
of approx. 10 minutes.
Loosen up the laundry by hand,
start the drying programme
–> page 18.
Turn on the tap.
Select the drying time according to the
load size.
Once the programme has ended:
adjust the load quantity, select a
suitable drying programme and restart.
If necessary, clean the fabric softener
compartment insert and fit it correctly
in compartment i.
Turn on the tap.
Reduce the load size.
Select a suitable drying time.
The programme continues when power
is restored. If you wish to remove the
laundry during a power cut, you must
first drain out the water –> page 21.
Check whether:
- the plug is plugged into the socket
correctly
-the circuit breaker (fuse) has tripped;
call the after-sales service. –
> page 25.
Select the programme
Empty p + Spin 0 and press
‹ Start/Pause.
Wait until appears on the
display panel.
Unlock the door mechanically.
24