What To Do If - Siemens WD14D366HK Instruction Manual And Installation Instructions

What to do if...

Fault code
—Ÿ
–©'š
Other fault codes are only for use by the after-sales service. Make a note of the fault code to inform the after-
sales service.
Fault
Programme does not start.
The maximum spin speed
cannot be set.
The water is not drained.
Detergent residues in the
detergent drawer.
Risk of electric shock
Repairs must only be carried out by customer services or authorised
technicians.
If repairs are needed, or if you cannot rectify a fault yourself with the help
of the following table:
 Set the programme selector to Off.
 Disconnect the washer-dryer from the power supply.
 Turn off the tap.
 Call the after-sales service –> page 25.
The is not closed properly. Try to close the door properly.
The water protection system has been activated. Disconnect the appliance from
the mains, turn off the tap and contact the after-sales service
Water is not entering the appliance. See the fault Water is not flowing in.
The water is not drained. See the fault Water is not drained.
Not a fault! The unbalanced load detection system has detected an unbalanced
load caused by laundry items. The fluff removal cycle cannot start. Remove the
laundry.
Maximum or minimum drying load not taken into account. HI/End or LO/End
flash alternately in the display. See information for the Drying result not
satisfactory fault.
Possible cause
The ‹ (Start/Pause) button has not
been pressed.
A delayed start time has been
selected.
Power cut.
The delayed start time that was
selected has been cleared.
The door is not properly closed.
Plug not inserted properly into socket. Insert plug correctly.
The maximum spin speed depends on
the programme selected.
Drain hose is twisted.
Detergent pump is blocked.
Damp or lumpy detergent.
Remedial action
Press the ‹ (Start/Pause) button.
The washer-dryer starts once the delay
time has elapsed. If necessary, change
the finished in time –> page 16.
Make a new delayed start time
selection or start a programme
immediately:
Press the ‹ (Start/Pause) button.
Close the door.
Change programme as required.
Fit the drain hose correctly.
Clean the drain pump –> page 21.
Clean and dry the detergent drawer –
> page 20.
Use the measuring aid for liquid
detergent.
22