Using The Function Stored In The Memory Of The Rm-Ip10; Setting A Limit On The Maximum Panning/Tilting Speed; To Return To The Factory Setting - Sony RM-IP10 Operating Instructions Manual

Using the Function
Stored in the Memory of
the RM-IP10
The following function for panning/tilting operations
with the RM-IP10 is stored in the memory of this unit.
Setting a limit on the maximum
panning/tilting speed
You can limit the panning/tilting speed obtained when
you incline the joystick at the maximum angle.
1
Hold the PAN-TILT RESET button for more than a
second while pressing the SHIFT button.
All of the CAMERA buttons 1 to 7 flash.
2
Press the CAMERA button corresponding to the
speed you want to set, as shown in the table below.
CAMERA Maximum panning/tilting speed
button
BRC-Z700,
BRC-H900
1 3.5 degrees/sec.
2 6.4 degrees/sec.
3 11 degrees/sec.
4 18.3 degrees/sec.
5 29 degrees/sec.
6 43 degrees/sec.
7 60 degrees/sec.
Only the CAMERA button you pressed flashes, and
the corresponding maximum panning/tilting speed
is set.
Note
If you use another RM-IP10 or you connect another
camera to this unit, set a limit on the maximum panning/
tilting speed again.
20
GB
Using the Function Stored in the Memory of the RM-IP10 / To Return to the Factory Setting
To Return to the Factory
Setting
1
2
BRC-Z330
4.4 degree/sec.
6.7 degrees/sec.
11.6 degrees/sec.
18.6 degrees/sec.
29.2 degrees/sec.
43.4 degrees/sec.
60 degrees/sec.
Turn the unit on while holding down the RESET
and SELECT buttons.
When the unit is turned on, buttons and indicators
flash as follows:
Yellow (1 second) t Green (1 second) t Red (1
second) t The GROUP/POSITION button that
was selected when the unit was turned off last (with
the upper or lower indicator beside of the SHIFT
button and GROUP indicator) and the CAMERA
button (2 seconds)
When the GROUP/POSITION and CAMERA
buttons flash in green, release the RESET and
SELECT buttons, then turn the unit off by pressing
the 1 button.
When the unit is turned on next time, the unit will
start with its factory settings.
Factory settings
• IP address of the IP remote controller:
192.168.0.10
• Subnet mask of the IP remote controller:
255.255.255.0
• Default gateway of the IP remote controller:
0.0.0.0
• Name of the IP remote controller: CTL1
• A camera IP address of 192.168.0.100 is assigned
to the camera number 1 of the camera group
number 1. No other IP addresses are assigned to
any of the other camera numbers or camera group
numbers.
• The unit starts with camera number 1 of camera
group number 1 selected.
• LOCK button: The lock function is not activated.