Sony RM-IP10 Operating Instructions Manual page 10

Switch Switch
4 5
10
GB
Location and Function of Parts
Mode
– When the selected camera
does not receive its own
number command from the
TALLY/CONTACT
connector:
The selected camera
switches to the camera
whose number matches that
of the command from the
TALLY/CONTACT
connector.
If two or more numbers are
received from the TALLY/
CONTACT connector, the
camera with the smallest
number is selected.
You can operate the
selected camera after
returning the joystick to the
neutral position.
(If you switch cameras and
the camera group number
changes, the GROUP/
POSITION button lights up
for about 1 second.)
• The selected CAMERA
button will flash in red and
yellow alternately.
• If two or more numbers are
received from the TALLY/
CONTACT connector,
CAMERA buttons which are
not selected will light in red.
You can select a camera by
pressing its respective
CAMERA button (lit in red).
• The tally lamp of the camera
receiving a command from
the TALLY/CONTACT
connector lights.*
Complement:
• When there are no commands
from the TALLY/CONTACT
connector, the tally lamp of
the selected camera lights.*
• If commands from the
TALLY/CONTACT connector
stop, the selected camera is
not changed.
* If es DIP 2 switch 5 is set to ON,
camera TALLY lamps will not
light.
Switch Switch Mode
4 5
ON OFF ON AIR TALLY mode:
The following actions are
performed for the number that is
input from the TALLY/
CONTACT connector only while
receiving the commands.
• The corresponding CAMERA
button lights in red.
• A camera can be selected
arbitrarily. Selecting a
CAMERA button lit in red
will make it flash in red and
yellow alternately.
• The tally lamp of the camera
receiving a command from
the TALLY/CONTACT
connector lights.*
* If es DIP 2 switch 5 is set to ON,
camera TALLY lamps will not
light.
OFF ON CONTACT mode:
The camera number that is
selected by the unit is output to
the connected peripheral device.
ON ON CONTACT (TALLY) mode:
The camera number that is
selected by the unit is output to
the connected peripheral device
and the tally lamp of the selected
camera lights.*
* If es DIP 2 switch 5 is set to ON,
camera TALLY lamps will not
light.
Switch 6: COMMAND selector
Switches the signal for the TALLY/CONTACT
connector between STD (standard method) and
EXPAND (expansion method).
Set ON for EXPAND, OFF for STD.
This setting is not effective for RS-232C/RS-422
(fixed as STD).
STD (standard method)
• When treating the TALLY/CONTACT connector
as input:
When one of the terminals 1 to 7 is short-circuited
to GND, the corresponding number is accepted.
(Two or more numbers can be simultaneously
accepted.)
• When treating the TALLY/CONTACT connector
as output:
Transmits to the external device by earthing one
of the terminals 1 to 7.
Tip
When using camera number 8 or higher, use
EXPAND.