Sony RM-IP10 Operating Instructions Manual page 9

Y VISCA RS-232C connector
Connect to the VISCA RS-232C IN connector of
the camera or the Optical Multiplex Unit.
Z VISCA RS-422 connector
Connect to the VISCA RS-422 connector of the
camera or the Optical Multiplex Unit.
An RS-422 connector plug is attached at the
factory.
wj TALLY/CONTACT connector
This connector is used for the tally lamp input or the
contact output.
Select the function of this connector using the DIP
switch on the bottom of the unit.
You can use the factory fitted RS-422 connector
plug for this connector.
wk DC IN 12V connector
Connect the supplied AC power adaptor.
wl 1 (power) switch
Press this switch to turn on/off this unit.
e; Cord clamper
Fixes the cord of the AC power adaptor.
1. Release the lock of the cord clamper.
2. Connect the supplied AC power adaptor.
Cord of the AC adaptor
3. Thread the cord of the AC power adaptor into
the cord clamper, then close the lock.
Bottom
Notes
• The Mac address is printed on the bottom of the IP
remote controller.
• Set the switches before you turn on the power of this
unit. Otherwise, the setting is not effective (except for
DIP 2 switches 1 and 2).
ea DIP 1 switch
Cord clamper
ea es
Switch 1: Serial/LAN connection selector
Selects the communication method.
Set ON for serial connection, or OFF for LAN
connection.
Switch 2: RS-232C/RS-422 selector
Selects the RS-232C or RS-422 when DIP 1 switch
1 is set to ON.
Set to ON for RS-422, or OFF for RS-232C.
Switch 3: Communication baud rate selector
Selects the communication baud rate for RS-232C/
RS-422.
Set to ON for 38,400 bps, or OFF for 9,600 bps.
Switch 4, 5: TALLY/CONTACT switch
Selects the function of the TALLY/CONTACT
connector.
You can select the following functions.
Switch Switch Mode
4 5
OFF OFF NORMAL TALLY mode:
The following actions are
performed for the number that is
input from the TALLY/
CONTACT connector only while
receiving the commands.
• The selected camera switches
to the camera matching the
number of the command from
the TALLY/CONTACT
connector.
– When the selected camera
number matches that of the
command from the TALLY/
CONTACT connector:
The selected camera is not
switched, and can continue
to be operated.
Location and Function of Parts
9
GB