NEC D3 Quick Start Manual page 28

11. At the Set Network Parameters window,
type in the network addressing
information for each controller that will
be used on the array. The IP Address for
each controller should be unique and
should be reserved in any DHCP server
before configuring. After typing in the
network information for the array, click
Next to continue.
12. After you type in the network information
for the array, a confirmation window will
appear. Verify that the information
entered was correct, and then click Set
to continue.
If the information is not correct, click
Back and type the information again
before continuing.
13. At the Set Host Connection Port
Parameters window, review the port
parameters for the array. If any
parameters need to be changed,
highlight the port to be changed and
click Edit on the right of the port list.
After all ports are configured correctly,
click Next to continue.
NEC D3/D4 Quick Start Guide 26