Battery Charge - Panasonic KX-TG1313EG Operating Instructions Manual

TG1311_1312_1313EG(e).book Page 7 Tuesday, October 21, 2008 5:04 PM

Battery charge

Place the handset on the base unit or charger for about 7 hours before
initial use.
Battery level
Battery icon Battery level
High
5
L When flashing: Fully charged.
Medium
6
Low
7
L When flashing: Needs charging.
Panasonic Ni-MH battery performance (supplied batteries)
Operation Operating time
In continuous use 17 hours max.
Not in use (standby) 150 hours max.
Note:
L It is normal for batteries not to reach full capacity at the initial charge.
Maximum battery performance is reached after a few complete cycles of
charge/discharge (use).
L Actual battery performance depends on a combination of how often the
handset is in use and how often it is not in use (standby).
L Even after the handset is fully charged, the handset can be left on the
base unit or charger without any ill effect on the batteries.
L The battery level may not be displayed correctly after you replace the
batteries. In this case, place the handset on the base unit or charger and
let it charge for at least 7 hours.
Controls
Handset
A Receiver
B Display
C {k} (Phonebook)
D {C} (Talk)
N
E Navigator
A
F {R} (Redial/Pause)
B G {R} (Recall/Flash)
H Microphone
C
I {j/OK} (Menu/OK)
D
J {ih} (Off/Power)
E
I
F K {C} (Clear)
J
L {INT}
K
G
L
H
M Charge contacts
M
N Ringer
Preparation
({e}/{v}/{>}/{<})
? (Volume: {e}/{v})
KX-TG1311:
To stop paging
KX-TG1312/KX-TG1313:
To stop paging/Intercom
7