Table of Contents
Advertisement
30401 English KX-TCD700NL
Before Requesting Help
Problem
While programming or searching,
the unit starts to ring and stops
the program/search.
The unit does not display the
caller's phone numbers.
does not function.
You cannot redial.
The paged handset does not
answer.
While using the intercom, two tones
sound.
The unit misdials when connected
to a PBX.
You cannot register the handset
in the base unit.
The battery strength is not
displayed correctly.
25/4/01
2:32 pm
• To answer the call, lift the handset or
•
Start again from the beginning after hanging up.
• Other telephone equipment may be interfering with
•
your phone. Disconnect them and try again.
• Other electrical appliances connected to the same
outlet may be interfering with the Caller ID
information. Telephone line noise may be affecting
the Caller ID information.
• The handset is too far from the base unit.
• The handset is engaged in an outside call.
• If the last number dialled was more than 24 digits
long, the number will not be redialled correctly.
• The handset is not in the same radio area.
• The handset is engaged in an outside call.
• The handset has been cancelled or has not been
registered. Register the handset in the base unit
(p.36).
• A call is being received. To answer,
•
.
• Check the pause function (p.25).
• The base unit has registered a maximum of 6
•
handsets or the handset has registered a maximum
of 4 base units.
• A wrong base unit password was entered. Enter the
correct password.
• There is interference from other electrical units,
locate the handset and base unit away from them.
• You must finish registration within 1 minute after the
ringer tone sounds, or programming will be
cancelled (p.36).
• Check that the battery type selection is correct
•
(p.34).
52
Page 52
Remedy
.
then
Advertisement
Table of Contents
