Panasonic HDC-TM10 Operating Instructions Manual page 123

Problem
Recording does not start
although power is
supplied to this unit and
the SD card is correctly
inserted.
Item other than the
touched one is selected.
The remaining time
indication or the elapsed
time indication is not
shown.
The unit arbitrarily stops
recording.
AF tracking does not
work when the object is
touched.
Auto focus function does
not work.
"CONDITION TOO DARK,
OR OPEN LENS COVER."
is displayed.
Colour balance of images
is strange when
recording in a place such
as a gymnasium.
≥ A message is displayed and you cannot record when the
built-in memory does not operate normally, or when the SD
card cover cannot be closed due to failure of the SD card
cover. In this case, press the recording start/stop button to
display the media change message, allowing you to change
the recording media.
≥ Calibrate the touch screen. (l 32)
≥ If you set [SETUP] > [DISPLAY] > [OFF], indications
other than warnings and date etc. are not displayed. (l 25)
≥ Use an SD card that can be used for motion picture
recording. (l 18) When the unit stops while a usable SD
card for recording motion pictures (l 18) is used, the data
writing rate has deteriorated. We recommend formatting the
SD card being used. (l 83)
≥ If [AGS] is [ON], record in the normal horizontal position or
set [AGS] to [OFF]. (l 53)
≥ Many repeated recording and deletion of motion pictures
may reduce the usable time for recording on a media you
use. In that case, format the media.
≥ Touch the part of the object that has specific colour such as
the part that is different from the surrounding. (l 46)
≥ Set to Intelligent auto mode to on or off.
≥ If you are trying to record a scene which is hard to bring into
focus in auto focus mode, use the manual focus mode to
adjust the focus. (l 34, 63)
≥ Before turning on the power, open the lens cover.
≥ This message may also be displayed when recording in a
very dark location.
≥ In a place with multiple light sources, such as a gymnasium
or a hall, set the white balance setting to
mode2). If you cannot record clearly with the
mode2), set it to
Check points
(Manual adjustment mode). (l 61)
(Indoor
(Indoor
123
VQT2D32