Table of Contents
Advertisement
Camera interfaces
Gigabit Ethernet port
Mako I/O connector pin assignment
Pin Signal
1 Out 1
7
4
8
6
3
1
2 Out 2
5
2
3 Out 3
4 In 1
5 Camera In GND In
6 Camera Out
Power
7 Camera Power ---
8 Ext GND
The Gigabit Ethernet port conforms to the IEEE 802.31000BASE-T standard for
Gigabit Ethernet over copper. To prevent EMI (electromagnetic interference)
and for best performance, Category 6 (or higher) cables with S/STP shielding
and connectors are recommended. Applications with longer cable lengths or
harsh EMI conditions require Category 7 (or higher) cables.
Note
• Cable lengths up to 100 m are supported.
• The 8-pin RJ-45 jack provides a pin assignment according
to the Ethernet standard (IEEE 802.3 1000BASE-T).
• All Mako cameras are PoE capable (802.3af/at).
• If both interfaces are used for power (I/O and GigE con-
nector via PoE), the camera will only use the power from
the I/O connector.
Accessories
• Cables are available from AVT:
http://www.alliedvisiontec.com/emea/products/
accessories/gige-accessories.html
Direction Level
Out
Open emitter, max. 20 mA
Out
Open emitter, max. 20 mA
Out
Open emitter, max. 20 mA
In
U
up to 36 V with external resistor
of 3.3 k in series
U
---
In
Common VCC for outputs max.
30 V DC
12–24 V DC +/- 10%
---
GND for ext. Power
Figure 27: Camera I/O connector pin assignment
The General Purpose I/O port uses a Hirose HR25-7TR-8PA(73) connector on the
camera side. The mating cable connector is Hirose HR25-7TP-8S.
Note
The cable side Hirose connector is available for purchase
from AVT.
AVT P/N: K7600503
(high) = 3.0–24.0 V
in
(low) = 0–1.0 V
in
Description
Output 1
Output 2
Output 3
Input 1
GND for input
Power input for opto-
isolated outputs
Camera power supply
External Ground for
external Power
Mako Technical Manual V2.1.0
39
Advertisement
Table of Contents
