Table of Contents
Advertisement
Camera cleaning instructions
Camera cleaning instructions
Warranty
Avoiding the necessity of camera cleaning
This chapter describes safety instructions/cautions valid for Mako cameras in
case of cleaning lenses, optical filters/protection glass or sensors.
Note
• Please read these instructions before you contact your
AVT camera dealer for assistance.
• Ask your AVT camera dealer if you are not familiar with
the procedures described below.
www
For details about camera warranty duration and sen-
sor warranty terms, visit:
http://www.alliedvisiontec.com/emea/support/
warranty.html
Caution
Warranty precautions
• To ensure your warranty remains in effect:
– Do not open the camera housing.
– Follow instructions described below.
– Use only optical quality tissue/cloth if you must clean
– Use only optics cleaner (60% ethyl alcohol, 40%
– Do not use compressed air which can push dust
• AVT does not warranty against any physical damage to
the sensor/filter/protection glass or lenses. Use utmost
care when cleaning optical components.
When screwing/unscrewing the camera lens or dust cap, hold the camera with
the C-Mount / CS-Mount opening towards the floor as shown in figure 1. This
minimizes the possibility of any contaminants falling on the glass surface.
Always store cameras and lenses with dust-caps installed.
a lens or filter.
ether). Never use aggressive cleaners like benzine or
spirit. Such cleaners may destroy the surface.
into camera and lens.
Mako Technical Manual V2.1.0
10
Advertisement
Table of Contents
