Telstrom DF-IP-S-1B Installation Manual page 19

3) Lighting Mode: The relay will close when the tenant answers the
call from the door phone, and will remain closed for a period of
seconds after the call is hung-up.
4) Bell Mode: The relay will close when someone pushes a button on
the door phone and will open after a period of
5) Sequence Relay Mode: In this mode relay 1 is activated for
seconds, then Relay 2 is activated for
1 is activated it follows the sequence. Relay 2 can be opened
separately.
2
External Day/Night Change Over Code: [2 to 6 digits]
The tenant when outside the property can change the day/night mode
from the door phone by pushing the buttons 1 & 2 in the correct
sequence. E.g. The tenant is going on holiday and the night mode
number is forwarded to the tenants mobile, so changing to night mode
"121121" all visitors at the door phone would call the tenants mobile.
Requires a two button IP Door Phone.
Tips: Don't use similar codes for external use. E.g. 12221 & 12222
5
Tenants phone codes: [1-2 digits]
The tenant can open relay 1 or 2 individually or at the same time
depending on the code entered. Setting the same code for both relays
will open both relays when the tenant enters the DTMF command from
their handset. The tenant can activate the relays during a call to or
from the door phone. To use a single digit command prefix the code
with "*" e.g. *1
6
Relay duration [in seconds 01 – 99]
7
Incoming call control
Example: If the tenant gave access to a visitor to park their car, and the
electric gate opens and while this happens the tenant accidently enters
www.telstrom.net
6
x seconds.
6
x seconds. Whenever Relay
6
x
6
x
18