Page 2
Overview Thank you for purchasing the Telstrom IP Door Phone, it is an ideal door entry solution for apartments, offices or gate control. The Telstrom IP Video Door Phone can be used to replace traditional intercoms, by using your existing LAN / Ethernet cabling. It can be connected to a wide range of devices: ...
Flush or Surface mount options. Two NC / NO relays Variable Volume, Microphone, Echo adjustment (Trim Pots) Board heating system to avoid condensation. Opening / Closing Relays via DTMF Changing Day/Night profile via DTMF www.telstrom.net...
VAILABLE RODUCTS DF-IP-S-1B DF-IP-S-2B DF-IP-S-1B-C-AV DF-IP-S-1B-C DF-IP-S-2B-C VAILABLE PTIONS Download Windows Pop Application (included) The application and POP-UP application is a video and SIP softphone for setup guide from use with the IP door phone. www.telstrom.net www.telstrom.net...
SIP end point using IP addresses e.g. Door Phone to SIP Desk Phone etc. The optional video camera can be connected via: Windows PC running the Telstrom Pop-Up application. Computer with a SIP video softphone H.263 Video Desk Phone. E.g. GXV-3000 ...
/ switches. Either “NO” Normally Open or “NC” Normally Closed” depending on your requirements. The contacts on both relays are galvanically isolated from each other and from other circuits. www.telstrom.net...
201 and if 201 is busy, then it will call the second stored number against that speed dial button, e.g. Marg on her mobile 12345678. Also, if the visitor presses a button twice it will call the second number, eg. Marg on her mobile 12345678. www.telstrom.net...
1. Push a Speed Dial Button with assigned phone number. The Door Phone will place a call to the desired tenants number (or IP address in Peer to Peer mode) depending what Mode it is currently in (refer to Time Profile). www.telstrom.net...
Open either 1,2 or both relays. E.g. Open the Door (relay 1) and switch the light on (relay 2) via DTMF or PC Change Time Profile e.g.Day/Night or Busy via DTMF or PC Hangup the call, which hangs up the Door Phone via DTMF or www.telstrom.net...
Relays 2. For example the tenant could change to night mode, when he leaves his Premises, so when visitors press the button on the door phone, calls go through to the (second group speed bin) to the tenants mobile. www.telstrom.net...
IP Video Desk Phone running SIP 2.0 and H.263 Video Protocol. e.g. Tornado M20, Grandstream GXV-3000, Yealink vp-2009p, Tanberg E20, Computer based Soft Phone running SIP 2.0. e.g. Telstrom Video Pop-up, Counterpath Bria, X-lite etc. Computer based Soft Phone running SIP 2.0 and H.263 Video Protocol.
In this mode the Door Phone registers against either an IP PBX or an ITSP as a SIP extension. The DoorPhone is seen as a normal extension of the PBX and can make and receive calls. Set DIP switch 2 (down) www.telstrom.net...
Door Phone on 192.168.1.250 (default). Point your browser to http://192.168.1.250 Username: admin Password: 1234 The first page will show the view of the video camera (if installed). Click setup to configure the Door Phone. www.telstrom.net...
Direct dialing – e.g. calling extensions via the keypad. Or b.) Dialing a speed bin number 1-64. If the optional keypad (IP Modular only) is attached, what is the installed position of it. i.e. What module number / position has the keypad been installed. www.telstrom.net...
Ask your IP PBX or ITSP administrator for the relevant codes to be used. These should match the device you are connecting to. To change the microphone and speaker gains as well as adjust the levels of the echo canceller refer to Audio Volumes. www.telstrom.net...
Camera Mode: In this mode the relevant relay will close when the tenant answers a call from the door phone and the relay will open when the call is hung-up. www.telstrom.net...
Page 19
“*” e.g. *1 Relay duration [in seconds 01 – 99] Incoming call control Example: If the tenant gave access to a visitor to park their car, and the electric gate opens and while this happens the tenant accidently enters www.telstrom.net...
The delay in seconds to place the next call if the first call is unanswered after x seconds. Signal with a tone to the tenant when a relay has been opened and closed. Signal with a tone to the tenant when other events occur. www.telstrom.net...
78 after 123456 hours. Prox If mode (Busy) then call 123456 78 if 201 is busy. If Door Phone set as Peer to Peer. If e.g. mode is 192.16 192.168 (Day/Ni 8.10.16 .10.150 ght) then call 192.168 .10.150 after www.telstrom.net...
System Settings At the top of the screen displays the current firmware and SIP firmware versions, check www.telstrom.net later versions. To try and fault find problems you can start enhanced logging and then place the call and view the log file to diagnose the problem.
You can backup save the current configuration and load previous configurations. View Video The view video page shows a JPG stream of images coming from the Door Phone camera. The resolution, frame rate etc can be changed. Refer to Video Settings. www.telstrom.net...
Power supply of lighting 12VDC ± 2V, 10-12VAC ± 2V through, switches and heating Max. consumption 300mA 12VDC Max. voltage of switch contact at I < 1A Max. current of switch contact at U < 30 V Operational temperature -20 to +50°C www.telstrom.net...
willful damage of product incorrect use of product caused by other use than specified in operating manual (e.g. installation, programming) damage caused during product transport to customer and from supplier www.telstrom.net...