Table of Contents
Advertisement
5 HANDLING CC-LINK EMBEDDED I/O ADAPTER
5 HANDLING CC-Link EMBEDDED I/O ADAPTER
5.1 Precautionary Notes for Handling and Installation
DANGER
CAUTION
5
5 - 1
The precautionary notes when handling and installing the CC-Link embedded I/O
adapter for the CC-Link system are described below.
• Do not touch the terminals or connector while the power is on.
Doing so may cause electric shock or malfunction.
• Make sure that there are no foreign substances such as sawdust or wiring debris
inside the CC-Link embedded I/O adapter.
Such debris could cause fire, failure or malfunction.
• Do not disassemble or modify the CC-Link embedded I/O adapter.
Doing so could cause failure, malfunction, injury or fire.
• Do not directly touch the CC-Link embedded I/O adapter's conductive parts.
Doing so could cause malfunction or failure in the CC-Link embedded I/O adapter.
• Because the case of the CC-Link embedded I/O adapter is made of resin, be careful
not to drop it or expose it to strong impact.
It may damage the CC-link embedded I/O adapter.
• When disposing of this product, treat it as industrial waste.
• Use the CC-Link embedded I/O adapter in an environment that meets the general
specifications contained in this manual.
Using this adapter in an environment outside the range of the general specifications
could result in electric shock, fire, malfunction, and damage to or deterioration of the
product.
• Before mounting or dismounting the user board loaded with the CC-Link embedded
I/O adapter to or from an enclosure, always switch power off externally in all
phases.
Failure to do so may damage the CC-Link embedded I/O adapter or cause
malfunction.
(1) Restrictions on close installation
Because of heat generation, do not install the CC-Link embedded I/O adapters
closely to each other.
Install the CC-Link embedded I/O adapters at least 5mm away from each other.
User board
5mm or more
MELSEC-A
5 - 1
Advertisement
Table of Contents
