Chauvet Intimidator Hybrid 140SR Quick Reference Manual page 5

MAIN LEVEL PROGRAMMING LEVELS
Lamp
Setting
Setup
(cont.)
Special Set
Running Mode
Sys Info DMX Address
Lamp On Time
Remain Time
DMX Linking
The Intimidator Hybrid 140SR can work with a DMX controller. Instructions for connecting and configuring this product for
DMX operation are in the User Manual. If you are not familiar with DMX, download the DMX Primer from www.chauvetdj.com.
Starting Address
To ensure full access to all channels available in each DMX mode, the highest recommended DMX address is 494.
Master/Slave Connection
The Intimidator Hybrid 140SR uses the DMX data connection for its Master/Slave mode. Information about configuring
the Intimidator Beam 140SR for Master/Slave operation is in the User Manual, which is available from the Chauvet
website.
IRC-6 (Infrared Remote Control)
The Intimidator Hybrid 140SR can be operated with the CHAUVET IRC-6. For more information about the IRC-6,
download instructions for the IRC-6 or the Intimidator Beam 140SR User Manual from www.chauvetdj.com.
Intimidator Hybrid 140SR QRG Rev. 2
QUICK REFERENCE GUIDE
OFF
On/Off
ON
OFF
State/Power
On
ON
NO
Off Via DMX
YES
NO
On If DMX On
YES
NO
Off If DMX Off
YES
Ignition Delay 000–255
Low Power
000–255
Delay
NO
Reset Lamp
Time
YES
132
Lamp Power
140
Interval 10–250
NO
Remain Time
RESET
Reset
Factory Set
Ver: V_
_ _ _ _ _ _ _ Displays the current running mode
_ _ _
_ _ _ _ _
_ _ _ _ _
DESCRIPTION
Turns lamp on or off
Defines the status of lamp when powering up product
Allows the lamp to be turned off through DMX
Turns lamp on when DMX signal is detected
Turns lamp off when DMX signal is lost
Selects duration of delay between product powering
on and lamp turning on
Selects the duration of delay between shutter closing
and lamp enters low power mode
Resets lamp time counter (for when lamp is replaced)
Select if installed lamp is 132 W Osram HRI
Select if installed lamp is 140 W Osram HRI
Defines number of hours between maintenance
Resets maintenance timer
Resets the product
Loads factory defaults
Displays the software version
Displays the current DMX address
Displays how long the lamp has been running
Shows amount of time remaining in maintenance cycle
EN
4