Sunny MINI CYCLE User Manual

Sunny MINI CYCLE User Manual

Advertisement

MINI CYCLE
NO. 030
IMPORTANT: Read all instructions carefully before using this product. Retain
owner's manual for future reference. For customer service, please contact:
support@sunnyhealthfitness.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MINI CYCLE and is the answer not in the manual?

Questions and answers

Summary of Contents for Sunny MINI CYCLE

  • Page 1 MINI CYCLE NO. 030 IMPORTANT: Read all instructions carefully before using this product. Retain owner’s manual for future reference. For customer service, please contact: support@sunnyhealthfitness.com...
  • Page 2: Important Safety Instructions

    12. You must take care of yourself when lifting and moving the equipment so as not to injure your back. Always use proper lifting technique and seek assistance if necessary. 13. This equipment is designed for indoor and home use only! It is not intended for commercial use! WARNING: Do not stand on the Mini Cycle!
  • Page 3: Exploded Drawing

    EXPLODED DRAWING PARTS LIST DESCRIPTION Main Frame Front Stabilizer Rear stabilizer Right Pedal Left Pedal M6 Hex Bolt Washer Computer Base Reinforcement Tension Knob Knob Screw Crank Arm...
  • Page 4: Assembly Instructions

    ASSEMBLY INSTRUCTIONS STEP: 1 Attach the Front Stabilizer (No. 2) to the Main Frame (No. 1) using 2 Hex Bolts (No. 6) and 2 Washers (No. 7), tighten and secure with wrench. STEP: 2 Attach the Rear Stabilizer (No. 3) to the Main Frame (No.
  • Page 5 FIGURE 1 NOTE: When removing the Computer (No. 8), the wire from connecting the computer to the Main Frame (No. 1) of the Mini Cycle may become disconnected. Before re-inserting the computer back onto the Main Frame (No. 1), ensure that the wires are connected to each other as shown to the right of the page in (Fig 2.).
  • Page 6 EXERCISE COMPUTER KEY FUNCTIONS: MODE: Press to select function; (Time, Count, Total Count, Calories and Scan). OPERATION PROCEDURES: 1. AUTO ON/OFF: If the wheel is put into motion, or the mode button is pressed the computer will become active, and shall remain active while either of these two things continue to be done, however without any signal for approximately 4 minutes, power (computer), will turn off automatically.

Table of Contents