Troubleshooting - ProForm EMOTION2 User Manual

HOW TO USE A WORKOUT MODE
1. Turn on the power.
See HOW TO TURN ON THE POWER on page 12.
2. Select a preset workout.
To select a preset workout, press the MODE button
repeatedly until the desired workout is selected. All
three workout modes are automatically set to run for
15 minutes.
When this mode is select-
ed, the vibration platform
will start at the lowest
vibration frequency and will gradually increase the
frequency until it reaches the maximum frequency.
Next, it will gradually decrease the frequency until
it reaches the lowest frequency. Then, it will repeat
this sequence.
When this mode is select-
ed, the vibration platform
will start at the second
vibration frequency and will increase the frequency
by two frequencies until it reaches the highest fre-
quency. Then, it will decrease the frequency by two
frequencies until it reaches the second frequency.

TROUBLESHOOTING

Inspect all parts of the vibration platform regularly. Replace any worn parts immediately. Outer surfaces
of the vibration platform can be cleaned with a damp cloth and a mild, non-abrasive detergent; do not use
solvents to clean the vibration platform.
Most vibration platform problems can be solved by following the simple steps below. Find the
symptom that applies, and follow the steps listed. If further assistance is needed, see the telephone
number on the front cover of this manual.
PROBLEM: The power does not turn on
SOLUTION:
a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is
plugged into a properly grounded outlet (see page 11). Use only a single-outlet surge suppressor that
meets all of the specifications described on page 11. IMPORTANT: The vibration platform is not compatible
with GFCI-equipped outlets.
b. Check the reset/off circuit breaker located on the vibration
platform base near the power cord. If the switch protrudes
as shown, the circuit breaker has tripped. To reset the circuit
breaker, wait for five minutes and then press the switch back in.
PROBLEM: The power turns off during use
SOLUTION:
a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has
tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five min-
utes, and then plug it back in.
c. If the vibration platform still will not run, please see the front cover of this manual.
When this mode is select-
ed, the vibration platform
will begin at the lowest
vibration frequency and will increase the frequency
to the highest frequency. Then, it will alternate
between the highest frequency and the lowest fre-
quency.
3. Start a vibration session.
See step 5 on page 13.
4. Stop or pause a vibration session.
See step 6 on page 13.
5. When you are finished, switch the reset/off
circuit breaker to the "off" position and unplug
the power cord.
b
Tripped
8
Reset