Security Level; Access Codes - Nokia 6275I User Manual

9251758_6275i_1_en_au_oth_v1.0.fm Page 60 Tuesday, August 22, 2006 10:24 PM
S e t t i n g s
Restrict sent calls—Set restrictions
on making calls.
Restrict rcvd. calls—Set restrictions
on receiving calls.
4. Select whether to block or allow
numbers:
Blocked numbers—Set the numbers
the phone can only block,
allowing all the rest.
Allowed numbers—Set the numbers
the phone can only call or receive,
blocking all the rest.
5. Select one of these options: Select,
Add restriction (unavailable with
memory full), Edit (unavailable
with no number added), or
(unavailable with no number
added).
Note: With restricted calls,
you may still call the official
emergency number
programmed into your device.

Security level

Your device can be set to different
security levels to control device use
and memory settings. In standby mode,
select Menu > Settings >
Security level. Enter your security code,
and select OK and one of the following
options:
None—Disable security level
protection.
60
Memory—Enable or disable memory
protection.
Phone—Enable or disable phone
protection.

Access codes

You can change your security code and
PIN code. Avoid using codes similar to
emergency numbers such as 911 to
prevent accidental dialling of the
emergency number.
Change security code
The security code controls access to
features such as the security level and
is supplied with the phone. The preset
Delete code is 12345. When you change the
security code, keep the new code
secret and in a safe place, separate
from your phone
If you enter the wrong security code
five times in succession, you will not be
able to enter a code for 5 minutes,
even if you power off the phone
between incorrect entries.
1. In standby mode, select
Settings > Security
codes > Change security
Security >
2. Enter the current security code
(default is 12345), and select OK.
3. Enter the new security code (up to
10 characters), and select OK.
4. Enter the new security code again,
and select OK.
Menu >
> Access
code.