Ultra Dma Data Out Commands - Fujitsu MPF3204AH Product Manual

10) If the host has not placed the result of its CRC calculation on DD (15:0) since first
driving DD (15:0) during (9), the host shall place the result of its CRC calculation on
DD (15:0) (see 5.5.5).
11) The host shall negate DMACK- no sooner than t
DSTROBE and negated DMARQ and the host has asserted STOP and negated
HDMARDY-, and no sooner than t
calculation on DD (15:0).
12) The device shall latch the host's CRC data from DD (15:0) on the negating edge of
DMACK-.
13) The device shall compare the CRC data received from the host with the results of its
own CRC calculation. If a miscompare error occurs during one or more Ultra DMA
burst for any one command, at the end of the command, the device shall report the first
error that occurred (see 5.5.5).
14) The device shall release DSTROBE within t
15) The host shall neither negate STOP nor assert HDMARDY- until at least t
host has negated DMACK-.
16) The host shall not assert DIOR-, CS0-, CS1-, DA2, DA1, or DA0 until at least t
negating DMACK.
5.5.4

Ultra DMA data out commands

5.5.4.1 Initiating an Ultra DMA data out burst
The following steps shall occur in the order they are listed unless otherwise specifically allowed
(see 5.6.3.7 and 5.6.3.2 for specific timing requirements):
1) The host shall keep DMACK- in the negated state before an Ultra DMA burst is initiated.
2) The device shall assert DMARQ to initiate an Ultra DMA burst.
3) Steps (3), (4), and (5) may occur in any order or at the same time. The host shall assert
STOP.
4) The host shall assert HSTROBE.
5) The host shall negate CS0-, CS1-, DA2, DA1, and DA0. The host shall keep CS0-, CS1-,
DA2, DA1, and DA0 negated until after negating DMACK- at the end of the burst.
6) Steps (3), (4), and (5) shall have occurred at least t
host shall keep DMACK- asserted until the end of an Ultra DMA burst.
7) The device may negate DDMARDY- t
device has negated DDMARDY-, the device shall not release DDMARDY- until after the
host has negated DMACK- at the end of an Ultra DMA burst.
8) The host shall negate STOP within t
STOP until after the first negation of HSTROBE.
after the host places the result of its CRC
DVS
after the host negates DMACK-.
IORDYZ
before the host asserts DMACK-. The
ACK
after the host has asserted DMACK-. Once the
ZIORDY
after asserting DMACK-. The host shall not assert
ENV
C141-E106-01EN
after the device has asserted
MLI
ACK
after the
after
ACK
5 - 79