Alarm Mode; Setting The Alarm Time - Grundig SONOCLOCK 620 Manual

6: 00 a i
6: 3 0 a i
f
FM
BAYER N 3
6: 3 0 a i
1
6: 3 0 a i
e 1 e

ALARM MODE

Setting alarm time and type
You can enter two different alarm times and select between two different
alarm types.

Setting the alarm time

1 Enter the first alarm time by pressing and holding down the
»ALARM 1« button.
– Display: the set alarm time and »A 1«.
2 Set the desired alarm time with
3 Release »ALARM
Note:
Repeat procedure for the second alarm time with
Alarm with radio station
1 Switch on device with »ON/OFF«.
2 Select channel position with the
the desired level with »VOLUME«.
3 Switch off device with »ON/OFF«.
4 Activate the first alarm time by pressing
appears in the display.
– The device switches to alarm time 1 and switches off again after
90 minutes.
– While the alarm sounds, »
Note:
Repeat procedure for the second alarm time with
Alarm with signal tone
Your device is equipped with a dynamic signal tone; this means the volume
of the signal tone becomes increasingly louder as it sounds.
1 Switch off device with »ON/OFF«.
2 Activate first alarm time by pressing
in the display.
– The device switches to alarm time 1; the signal tone becomes increa-
singly loud. The signal tone is switched off after a maximum of
90 minutes.
– While the alarm sounds, »e1« flashes in the display.
Note:
Repeat procedure for the second alarm time with
The signal tones for alarm time 1 and alarm time 2 are different.
______________________________________
»+ « or »–
1«.
»1 ... 10
1« flashes in the display.
»ALARM
« (TUNING).
»ALARM 2«.
« buttons, adjust volume to
»ALARM 1« until »
»ALARM 2«.
1« until »e1« appears
»ALARM 2«.
1«
23