Important Information; Important Safety Instructions; Operating Considerations; Important Safety Notes - Matrix mvBlueFOX3 Technical Manual

5 Important information

5.1 Important safety instructions

We cannot and do not take any responsibility for the damage caused to you or to any other
•
equipment connected to the mvBlueFOX3 . Similarly, warranty will be void, if a damage is
caused by not following the manual.
Handle the mvBlueFOX3 with care. Do not misuse the mvBlueFOX3 . Avoid shaking,
•
striking, etc. The mvBlueFOX3 could be damaged by faulty handling or shortage.
Do not use accessories not recommended by the product manufacturer as they may cause
•
hazards.
The product should be situated away from heat sources such as radiators, heat registers,
•
stoves, or other products (including amplifiers) that produce heat.
Using the board-level version:
•
Provide sufficient cooling because single components can reach high temperatures.
♦
Handle with care and avoid damage of electronical components by electrostatic
♦
discharge (ESD):

5.2 Operating considerations

5.2.1 Important safety notes

Use this camera with a 12V to 24V DC power supply with following specifications: 12V, 2.5A
•
5% or 24V, 1.25A, 5%.
Using the Model without housing (-M1)
•
Warning:
♦
Handle with care and avoid damage of electronical components by electrostatic
♦
discharge (ESD):
Observe that flammable objects, water or metal do not enter the camera interior. These may
•
lead to failure or accident.
Do not modify the camera or use the camera with external covers removed. These may
•
cause failure, void any warranties and pose a safety hazard.
Stop using the camera at the approach of electrical storm (thunder audible). Protect the
•
camera from rain if using it outdoors.
In event the camera shows any abnormality, switch off the camera and disconnect the power
•
cord. Contract MATRIX VISION.
Discharge body static (contact a grounded surface and maintain contact).
◊
Avoid all plastic, vinyl, and styrofoam (except antistatic versions) around
◊
printed circuit boards.
Do not touch components on the printed circuit board with your hands or with
◊
conductive devices.
Provide sufficient cooling because single components can reach high
temperatures. Inadequate and incorrect cooling invalidate the guarantee.
Discharge body static (contact a grounded surface and maintain contact).
◊
Avoid all plastic, vinyl, and styrofoam (except antistatic versions) around
◊
printed circuit boards.
Do not touch components on the printed circuit board with your hands or with
◊
conductive devices.
or Model without housing (-M2) :
17