Matrix mvBlueFOX3 Technical Manual page 171

18 Use cases
Note:
To get suitable image results, it might be necessary to increase the gain or the illumination.
These settings result in a max. "frame rate" of "2.5 frames per second".
To adjust the opto-mechanics (focus, distance, illumination, etc.), you can use the area mode of the
sensor. That's a main advantage of an area sensor with linescan mode compared to a linescan
camera!
You will need the following pins of the mvBlueFOX3 :
Pin. Signal (Standard version)
1 GND
2 12V .. 24V
4 Opto DigIn0 (line4)
Setting the application in wxPropView
Summary of our sample:
Property name
wxPropView
Device Scan Type
Height (in pixels)
Offset Y (in pixels)
Exposure Time (in
microseconds)
Trigger Mode
Trigger Source
ImageRequestTimeout_ms
(in milliseconds)
Description
Common ground
Power supply
The output signal A of the
incremental encoder
GenICam
Setting
Control
Linescan Device Control
Image Format
1000
Control
Image Format
500
Control
Acquisition
250.000
Control
Acquisition
On
Control
Acquisition
Line4
Control
-
0 ms
Comment
This is necessary otherwise there will
be error counts and no frames are
created.
163