Replace The Filters - Philips AC4372 User Manual

7 Replace the
filters
The indicator of the filter replacement
indicates the respective filters ( ,
have to be replaced.
Note
•
Lifetime of the filter is based on the volume of air
purified, it may differ from the way of using. In heavily
polluted environment, the filter lifetime may be shorter
than the recommended time.
•
If you remove the front panel for filter changing while
the purifier is switched on, all lights on the control
panel will be off.
•
Once the front panel is placed back to the purifier, it
starts to run as its previous status .
•
The replaceable filters are not washable nor vacuum
cleanable.
For AC4372
Replace the multi-care filter, the activated
carbon filter, and the HEPA filter when the
respective indicators ( ,
For AC4374
Replace the integrated Multi-care filter when
the respective indicator ( )goes on.
This will last for approximately 2 weeks.
On the last day of the 2 weeks, the purifier
beeps every 30 minutes to inform you that the
filter needs to be replaced.
Note
•
Insert the filters in the correct position.
•
For AC4372, make sure you place the filters in the
order of HEPA filter, the activated carbon filter, the
multi-care filter, and then pre-filter.
•
For AC4374, make sure you place the filters in the
order of integrated Multi-care filter, and then pre-filter.
•
Make sure that the side with the tag is pointing towards
you.
16 EN
, or )
, and )go on.
1
Switch off the purifier and unplug it.
2
Place your fingers in the recesses of the
side panels and gently pull the front panel
towards you. Then lift the panel off the
hooks at the bottom of the purifier.
3
To remove the pre-filter, grab the two
projections and pull the filter towards you.
4
For AC4372, remove the multi-care filter,
activated carbon filter and HEPA filter
from the purifier.