Replace The Filters; Replace The Activated Carbon Filter And The Hepa Filter - Philips AC4014 User Manual

7 Replace the
filters
The filter replacement light (
filters have to be replaced.
Note
•
If you remove the front panel for filter changing
while the purifier is switched on, all lights on the
control panel will be off.
•
Once the front panel is placed back to the purifier,
all lights flash twice. Then, the purifier is off. Press
the button to switch on the purifier again.
Replace the activated carbon
filter and the HEPA filter
Note
•
The activated carbon filter and the HEPA filter are
not washable nor vacuum cleanable.
Replace both the activated carbon filter and
HEPA filter when the light goes on. This will
last for approximately 2 weeks.
On the last day of the 2 weeks, the purifier
beeps every 30 minutes to inform you that the
filter needs to be replaced.
Tip
•
When you remove or insert filters, place the
purifier against a wall for more stability.
16 EN
•
•
•
) indicates the
1
2
3
•
•
4
Note
Insert the filters in the correct position.
Make sure you place the filters in the order of
HEPA filter, activated carbon filter, and finally the
pre-filter.
Make sure that the side with the tag is pointing
towards you.
Switch off the purifier and unplug it.
Place your fingers in the recesses of the side
panels and gently pull the bottom part of
the front panel towards you. Lift the panel
out of the hooks at the top of the purifier.
2
1
Remove the filters using the tag on the filter.
Take the filters by both sides and gently
deposit them into the house hold trash bin.
Note
Do not touch the pleated filter surface, or smell
the filter as it has collected pollutants from the air.
Wash your hands after disposing of the used
filters.
Remove all packaging material from the
new filters.