Use The Air Purifier; Understand The Air Quality Light; Switch On - Philips AC4372 User Manual

4 Use the air
purifier
Understand the air quality
light
Color of the air quality
light
Blue
Dark purple
Purple
Red
The air quality light automatically goes on when
the purifier is switched on.
Note
•
The built-in air quality sensor measures the air quality
and automatically selects the appropriate color of
the air quality light. When the air is clean, the color
of the air quality light is in blue. When the air quality
deteriorates, the color of the air quality light changes
from dark purple to red.

Switch on

1
Put the plug of the air purifier into the
power socket.
» All lights go on from left to right in
cycle, and you hear a beep. Then, the
lights go out again.
» The air quality light shows 4 colors
successively.
10 EN
2
Air quality level
Very good
Good
Fair
Bad
3
Press the button to switch on the
purifier.
» The fan speed indicators
goes on.
Note
•
When the purifier is switched on, the air quality
sensor will take some time to measure the air quality
in the room. The air quality light changes its color and
eventually stays in the correct color in accordance with
the air quality..
Press and hold the
2 seconds to switch off the purifier.
2"
Tip
•
The purifier has a memory mode. It will recall the
previous settings of your last use.
•
If you disconnect the purifier from the power supply
after switching off, it will enter the default mode for
next use. The fan speed is
and
button for
.