Recording Setup Screen - Panasonic AG-HVX200AP Operating Instructions Manual

RECORDING SETUP screen

Display
Item
mode
REC FORMAT (P2) (Camera) Selects the recording format for P2 card.
P2
REC FORMAT (Camera) Selects the recording format for cassette tape.
(TAPE)
TAPE
480i REC MODE (Camera) Select the recording mode for a 480i recording format.
P2
REC FUNCTION (Camera) Selects the special recording mode. (Pages 48 - 50)
P2
ONE-SHOT TIME (Camera) Selects the one-shot recording time. (Page 50)
P2
INTERVAL TIME (Camera) Selects the interval time for interval recording. (Page 49)
P2
PREREC MODE (Camera) Sets PRE RECORDING to ON or OFF. (Page 48)
P2
REC SPEED (Camera)
TAPE (VCR)
(DUB)
AUDIO REC (Camera)
TAPE (VCR)
MIC ALC (Camera) Sets mic level auto control to ON or OFF. (Page 54)
P2 TAPE
MIC GAIN 1 (Camera) Sets the input level of the external microphone connected to the INPUT 1
P2 TAPE
MIC GAIN 2 (Camera) Sets the input level of the external microphone connected to the INPUT 2
P2 TAPE
25M REC CH SEL (Camera) Selects the recording audio channel for DVCPRO25 and DV formats. (Page 53)
P2
1080i/60i, 1080i/30P, 1080i/24P, 1080i/24PA, 720P/60P, 720P/30P, 720P/24P,
720P/30PN, 720P/24PN, 480i/60i, 480i/30P, 480i/24P, 480i/24PA
480i/60i, 480i/30P, 480i/24P, 480i/24PA
DVCPRO50, DVCPRO, DV
NORMAL, INTERVAL, ONE SHOT, LOOP
1F, 2F, 4F, 8F, 16F, 1s
2F, 4F, 8F, 16F, 1s, 2s, 5s, 10s, 30s, 1m, 5m, 10m
ON OFF
Selects the recording time mode.
SP: SP (standard) mode
LP: LP (long play) mode
Selects the audio recording mode for conversion to PCM audio.
32K(12bit): 12bit/32kHz
48K(16bit): 16bit/48kHz
ON OFF
Set to ON to reduce distortion at high input levels.
This setting does not change the audio signal recording level. Use the AUDIO
control knob to adjust the audio signal recording level.
terminal. (Page 53)
-50dB -60dB
terminal. (Page 53)
-50dB -60dB
2CH, 4CH
<Notes>
• Even when 4CH is selected as this item's setting, the signals will be
input to two channels (always CH1 and CH2) when there are two 1394
input channels.
• Similarly, even when 4CH is selected, the 1394 output signals will be
delivered to two channels (always CH1 and CH2).
Description of settings
indicates the factory setting.
107