System Resetting; Cleaning - Panasonic AG-HVX200AP Operating Instructions Manual

System resetting

Reset the system microcomputer if you can no
longer operate the camera-recorder even though
its power is on or a similar kind of a problem has
occurred.
Use a pointed object to press the RESET button on
the camera-recorder.
The menu setting entered and memory contents
will not be cleared even when the system is reset.
Do not press the RESET button when the camera-
recorder is operating normally.

Cleaning

When cleaning, do not use benzene or thinner.
• Using benzine or paint thinners may deform the
camera-recorder and/or cause the surface finish
to peel off.
• Before proceeding with maintenance, remove the
battery or disconnect the AC cord from the power
outlet.
• Use a soft, clean cloth to wipe the camera-
recorder. To remove stubborn dirt, wipe the
camera-recorder with a cloth moistened with
kitchen detergent that has been diluted with
water and then use a dry cloth to take up the
remaining moisture.
Cleaning the Viewfinder
If there is dust inside the view finder, remove the
eye cup holder and get rid of the dust.
• The interior of the eye cup holder is specially
finished, so do not ever wipe it. If there is dust on
it, blow it off with an air blower.
• Remove the eye cup holder with the eye cup
attached by rotating it counterclockwise. (It will
be tightly screwed on.) When you do this, tilt the
view finder slightly upward.
• To amount the eye cup holder, align the ridges
and grooves of the eye cup holder and camera-
recorder, and turn clockwise until the holder
clicks into place.
RESET button
BARS SHUTTER SPEED SEL
RESET
CH 1 SELECT CH 2 SELECT INPUT 1 INPUT 2
INT(L) INT(R) ON ON
INPUT 1 INPUT 2 OFF OFF
INPUT 2
MIC POWER +48V
AUDIO
ZEBRA OIS
COUNTER RESET/TC SET
Eye cup holder
Eye cup
Projection
127