V-Belt - Yamaha Apex RX10GTY Owner's Manual

1. Coolant reservoir cap
2. Coolant recovery tank cap
3. Remove the coolant recovery tank cap,
add the recommended coolant until it
reaches the "COLD LEVEL" mark, and
then install the cap.
Recommended antifreeze:
High-quality ethylene glycol antifreeze
containing corrosion inhibitors
Antifreeze and water mixing ratio:
3:2
Total amount:
RX10GT 6.20 L (6.55 US qt,
5.46 Imp.qt)
RX10LTGT 6.80 L (7.19 US qt,
5.98 Imp.qt)
4. Start the engine, allow it to idle for several
minutes, and then turn it off.
5. Check the coolant level in the coolant
reservoir. If it is not full, remove the cool-
ant reservoir cap, fill the reservoir with the
recommended coolant, and then install
the cap.
Periodic maintenance and adjustment
6. Check for any coolant leakage.
TIP
If you find any leaks, consult a Yamaha deal-
er.
7. Install the top cover.
ESU12062

V-belt

EWS00401
WARNING
Coming in contact with the rotating V-
G
belt or clutch parts can cause severe in-
jury or death. Never run the engine with
the drive guard removed.
Make sure that the drive guard is tight-
G
ened securely before operating the
snowmobile to protect against severe
injury or death from a broken V-belt or
other part should it come off the snow-
mobile while it is in operation.
ECS00830
NOTICE
Never run the engine with the V-belt re-
moved. Clutch components can be dam-
aged.
The V-belt should be checked before each
ride.
To check the V-belt
1. Remove the shroud and the left side cov-
er, and then remove the drive guard.
(See page 41 for removal procedures.)
2. Check the V-belt for wear and damage.
Replace if necessary.
53