Readings On The Lc Display Of Program Data 420 - Nortec UL10 Operation Manual

CHARGER / DISCAHRGER UL10
♦ (0) or (V) the device returns to the main menu.
♦ (1) Starts the process of checking with the first stage– discharge with the nominal cur-
rent during 6 minutes. The key Р is hit to print out the protocol.
The additional data
•
the battery number
•
the user identification number
are input or confirmed by hitting the key ENTER↵.
After the key Р is hit and the additional data are input the process of checking of each battery
starts. The print-out reads:
• the battery number
• the operator identification number
An intermediate print-out is made by hitting Р once again. If the start key is pressed on the
positive probe of the measuring cable the voltages of individual batteries are registered.

6.9 Readings on the LC display of program data 420

For enclosed nickel-cadmium aircraft batteries = type 20 according to requirements VG 95 238 Т
110 BS with the nominal voltage 24 V and nominal capacity 4 Аh the check cycle = the operation
type should be selected by the key 4. Hence, after input of special data and confirmation by hitting
the key Р the program # 420 is started.
30
OPERATION MAUNAL
© NorTec Electronics 2014