Disassembly - Pioneer DV-366-S Service Manual

5

7.1.9 DISASSEMBLY

Note: Even if the unit shown in the photos and illustrations in this manual may differ from your product, the procedures
described here are common.
Diagnosis of the DVDM Assy
1
Bonnet and Tray Panel
1
Remove the Bonnet by removing the five screws.
2
Press the STANDBY/ON button to turn on the
power.
3
Press the 0 button to open the Tray.
4
Remove the Tray Panel.
5
Press the 0 button to close the Tray.
6
Press the STANDBY/ON button to turn off the
power.
How to open the Tray when the power cannot be on
Insert a screwdriver (small) into the slit located at the
bottom of the unit, and slide the projection of the Drive
Gear in the Loading Mecha. Assy in the direction of
the arrow, as indicated in the photo. If the Tray pops
out a little, fully pull it out by hand.
Projection
Drive Gear
5
6
Screwdriver (small)
Loading Mecha.Assy
Tray open
6
7
2 6
4
3
5
Tray
Tray Panel
DV-366-S
7
8
(SCRB Assy)
This is not installed in your product.
3 5
Slit
Screwdriver (small)
8
A
B
C
D
E
F
65