Advertisement
SET button.
When the position is determined, select 'END' and press the SET button to return to the SPECIAL menu.
● SYNC: In areas where the supply is at 60Hz, you can synchronize
the output phase of multiple cameras using the power synchronization
function (Line-Lock) without using a synchronization signal generator.
- INT: Internal Synchronization Type
- L/L: Power Synchronization Type, Line-lock
• Press the SET button.
• You can select a desired phase between 0 and 359.
☞Note
• When using AC power at 60Hz frequency, you can use the L/L type synchronization.
• When the power is DC 12V, the SYNC. menu is fixed to the 'INT' mode.
● MOTION DET:
If you connect an alarm device to this camera, you can monitor activity more efficiently, because
a signal is generated by the camera whenever motion is detected. The motion detection signal
is output through the MD OUT port.
When the SPECIAL menu screen is displayed, press the Up and Down buttons so that the arrow indicates
MOTION DET .
Set up the mode using the 4 direction buttons.
- SENSITIVITY: You can select up to 8 MD areas. When SENSITIVITY number is high, motion detection
22
Advertisement
