Replacing The Batteries And/Or Battery Cables; Disconnecting Battery Cables - Invacare FDX User Manual

Reverse this procedure to install the rear battery.
Remove the mounting screws A securing the rear shroud B to
1.
the rear shroud stand offs C.
2. Remove the rear shroud from the wheelchair base frame D.
Take note of position and orientation of the tie-wraps
and wiring bundles before cutting necessary tie-wraps
and repositioning the wiring bundles.
3. Locate the two wiring bundles, one on each side of the controller
and if necessary, cut the tie-wraps securing the wiring bundles to
the controller bracket.
Remove the tie-wraps E securing the right side wiring bundle
4.
F together
Remove the two mounting screws G securing the controller
5.
bracket H to the wheelchair base frame.
1163181-F~00
6. Lifting up on the controller bracket, disengage the controller
bracket from the wheelchair base frame.
7. Using one hand to support the controller bracket, use the
other hand to disconnect the two motor connectors I, the
rear battery wiring connector J, the joystick connector K
and the auxiliary wiring harness connector L(if equipped with
power seating system, running light package or other powered
accessory) from the controller
8. Set the controller bracket aside.
9. Disconnect the rear battery wiring connector M from the rear
battery connector N
WARNING!
– When removing or installing the rear battery,
DO NOT allow the controller bracket to
come in contact with the top of the battery.
ALWAYS remove the controller bracket from
the wheelchair base frame when removing the
batteries - otherwise injury or damage may occur.
10. Remove the rear battery O from the wheelchair base frame.
7.7 Replacing the Batteries and/or Battery
Cables

7.7.1 Disconnecting Battery Cables

1. Remove the batteries K.
2. Cut the tie-wrap J that secures the battery terminal cap in place.
Slide terminal caps I up onto the battery cables.
3.
Remove the mounting screw A and two lock washers B
4.
securing the POSITIVE (+) battery cable L-bracket C to the
POSITIVE (+) battery terminal D.
Set Up Maintenance
63