Panasonic HDC-HS300P/PC Operating Instructions Manual page 80

Night portrait
The shutter speed is 1/2 or more.
The flash is set to [ON].
Using a tripod is recommended.
Interval recording:
Still picture recording cannot be used.
Recording mode cannot be changed when the
interval recording is set.
If you turn off the power or change the mode to
, this function is canceled.
1 second of motion picture is recorded even if
24 frames are not recorded at the end of
recording.
Color balance and focus may not be adjusted
automatically depending on light sources or
scenes. If so, manually adjust these settings.
(F 83, 85)
Digital cinema:
Motion pictures recorded while this setting is
turned [ON] may not be played back properly
with a player that cannot support 24p video
signal playback.
Relay recording:
It does not allow the relay recording of still
pictures. However, even still pictures are
recorded to the SD card after relay recording.
is displayed on the thumbnail display
during the playback of a scene that was relay
recorded on the built-in memory.
Auto Ground-Directional Standby
The AGS function may activate and cause the
unit to pause the recording if you are recording
a subject right above or right below you.
Auto slow shutter:
When the shutter speed becomes 1/30, the
screen may be seen as if frames are missed
and afterimages may appear.
Digital cinema color:
When motion pictures recorded while this
function is turned [ON] are played back
with a TV not compatible with x.v.Color
colors may not be reproduced properly.
To play back images recorded in Digital cinema
color with vivid colors of wider color ranges, a
device compatible with x.v.Color
When these images are played back with
devices other than ones compatible with
™
x.v.Color , it is recommended to record the
images after this function is turned [OFF].
80
VQT1Z09
x.v.Color
compatible with the xvYCC format, an
international standard for expanded color in
motion pictures, and that follow the rules for
signal transmission.
Wind noise reduction:
When the Intelligent Auto Mode is set to on,
[WIND CUT] is set to [ON], and the setting
cannot be changed.
The sound quality may be changed if this
function is activated in strong winds.
If wind sound cannot be reduced with the wind
noise reduction function alone, set [BASS
SETTING] to [LOWCUT]. (F 76)
Microphone setup:
If you wish to record higher quality sound and
maintain realism even when zooming in, for
instance, when recording a music recital, we
recommend setting [MIC SETUP] to
[SURROUND].
Microphone level:
When the Intelligent Auto Mode is on, the
setting is fixed to [AUTO] and cannot be
changed.
When [MIC SETUP] is [ZOOM MIC], the
volume will be different depending on the zoom
rate.
Audio becomes stereo (2 ch) when input is
from an external microphone, and the front left
and front right gain values only work.
The microphone input level meter shows the
largest volume for the microphones.
You cannot record with the audio completely
muted.
Luminance:
Luminance is displayed while adjusting [IRIS]
even if [DISPLAY] is set to [OFF].
Histogram:
Histogram is displayed while adjusting [IRIS]
even if [DISPLAY] is set to [OFF].
™
,
™
is required.
™
is a name for devices that are