Cradlepoint ARC CBA850 Product Manual page 74

CBA850 | USER MANUAL Firmware version 5.4.0
CRADLEPOINT
IPV4 DHCP
Changing settings for the IPv4 DHCP server
is optional. The default selections are
almost always sufficient.
DHCP Server: (Default: Enabled) When the
DHCP server is enabled, users of your
network will be able to automatically
connect to the Internet without any special
configuration. It is recommended that you
leave this enabled. Disabling the DHCP
server is only recommended if you have
another DHCP server on your network and
it is configured properly.
Range Start and Range End: These
designate the range of values in the
reserved pool of IP addresses for the DHCP
server. Values within this range will be
given to any DHCP enabled computers on
your network. The default values are almost
always sufficient (default: 72 to 200, as in
192.168.0.72 to 192.168.0.200).
Example: The router uses an IP address of
192.168.0.1 for its primary network by default. A
computer designated as a Web server has a static IP address of 192.168.0.3. Another computer is designated as an FTP server with a static IP address of
192.168.0.4. The starting IP address for the DHCP server needs to be 192.168.0.5 or higher.
Lease Time: (Default: 720 minutes [12 hours]) Specifies how long DHCP-enabled computers will wait before requesting a new
DHCP lease. Smaller values are better suited to busy environments.
© 2015 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 72