Seiko I Infotech LP-1020 User Manual page 140

5-22
Downloaded From ManualsPrinter.com Manuals
■SCALE X (%)
SCALE Y (%)
When setting "SCALE MODE = MANUAL SCALE," values of the scale
applied to X and Y directions of the drawing are set up.
This setting is performed on the third hierarchy.
<Parameter (numerical value input method)>
0.01 to 1000.00
This setting is enabled when setting "SCALE MODE = MANUAL
SCALE." When it is set to 100%, the plot is produced in 1-to-1
magnification.
■PEN WIDTH SCALE (HP-GL, DSCAN only)
Sets the scaling down method, when the drawing is scaled down (in the
same X and Y proportion). This setting is performed on the third
hierarchy.
<Parameter (choice input method)>
ON Line width or interval between points are also scaled down.
Maximum line width is 16 mm (0.63 inches).
OFF Line width or interval between points are not scaled down.
■FIX SCALE A
FIX SCALE 9"
FIX SCALE 8.5"
Allows for setting the method of automatic scale from one fixed form to
another when setting "SCALE MODE = MANUAL SCALE." This
setting is disabled when plotting in the actual length or expanded fixed
form. This setting is performed on the third hierarchy.
Default value = 100
: Default value