Output Sel; Genlock - Panasonic AJ- E Operating Instructions Manual

Chapter 7 Menu description tables

7-2-4 OUTPUT SEL

Item/ Variable
Data storage range
VIDEO OUT SEL VBS For selecting the output signal of the VIDEO
VF OUT connector.
Y VBS: The normal composite signal is output.
VF:
Y:
C U F
OUTPUT CHAR TC For setting the type of characters to be
STATUS superimposed onto the output signals of the
MENU VIDEO OUT connector and MON OUT
ONLY connector.
TC:
The time code is displayed. (The menu
appears when the menu is displayed.)
<Note>
The time code display position moves
vertically in accordance with the camera ID
position.
STATUS:
All the same characters as the ones
superimposed on the viewfinder are
displayed. (The menu appears when the
menu is displayed.)
MENU ONLY:
Only appears when the menu is displayed.
Normally, nothing is displayed
C U F
MONITOR OUT ON For selecting whether to superimpose
CHAR OFF characters onto the MON OUT connector
signal. (It is not linked with the VIDEO OUT
CHARACTER switch.)
The characters which are superimposed are
the ones which are selected using the
OUTPUT CHAR menu item.
ON: The characters are superimposed.
OFF: The characters are not superimposed.
C U F
VF MODE EE/PB EE/PB: The images are played back in the
EE
EE:
C U F
The underlining in the variable range column indicates the setting in the preset mode.
84
Remarks
The viewfinder's Y signal is output. The
status display is also superimposed.
The component Y signal is output.
playback mode.
The camera images are displayed all
the time.

7-2-5 GENLOCK

Item/ Variable
Data storage range
GENLOCK INT For selecting the sync signal among the
EXT camera signals.
26P EXT INT:
EXT:
26P EXT: For synchronizing with the signal
C U F E
H PHASE COARSE –50 For making coarse adjustments to the
:
horizontal phase when setting up a system.
+00
:
+50
H PHASE FINE –128 For making fine adjustments to the horizontal
:
phase when setting up a system.
+000
<Note>
:
+127 This adjustment also affects the SC phase.
SC PHASE 0 For coarsely adjusting the SC phase during
COARSE 1 genlock.
:
3
SC PHASE FINE –75 For finely adjusting the SD phase during genlock.
:
<Note>
+00
When making GENLOCK adjustments to the unit,
:
+75
adjust H PHASE first, followed by SC PHASE.
Remarks
For synchronizing with the internal
reference signal regardless of the
reference signal which has been
supplied to the GENLOCK IN connector.
For synchronizing with the reference
signal which has been supplied to
the GENLOCK IN connector.
input via the 26-pin jack.