Adjusting The White Balance Manually - Panasonic AG-DVC30 Operating Instructions Manual

White balance adjustments
Adjusting the white balance
manually
In the set mode ( ), you can save the white
balance, which has been adjusted manually, in
the memory.
1
Place a white pattern in a location with the
same lighting conditions and light source as
the subject, then zoom in and fill the whole
screen with white.
A white object (a white cloth or white wall)
near the subject can be used instead of the
white pattern.
O Keep high-brightness spotlights and
yellow subjects off the screen.
2
Set the AUTO/MANUAL selector switch to
MANUAL.
O No adjustments can be performed with
this switch at AUTO.
AUTO
3
Press the WHITE BAL button and hold it
down until the display lights.
The display will start to blink immediately
after it lights.
O This operation can be performed even if
the setting mode for the white balance
has been selected.
(cont.)
4
The
automatically.
The screen then darkens for a moment
before the black balance is adjusted
automatically.
When
completed,
back to a lit display.
O Do not move the screen away from the
O If these steps are taken during shooting,
only the white balance will be adjusted.
O If the white balance cannot be adjusted
satisfactorily
extremely bright or extremely dark, the
display will blink slowly.
O The white balance cannot be adjusted
manually while digital zooming is performed
with "k160" selected as the D. ZOOM item
(P75) setting on the SW MODE screen.
MANUAL
1
white balance is
the adjustments
stops blinking and changes
subject until the adjustments
completed.
because
ENGLISH
now adjusted
have been
are
the place is
45 (E)