Table of Contents
Advertisement
Lighting The Barbecue
Lighting the barbecue is easy, but must be done with due care.
Make sure that the gas is turned on at the cylinder, or that gas is available to the barbecue. Also, ensure that the
hood and side burner lid are open.
Electronic Ignition: Follow below steps for lighting:
1. Open the hood during lighting.
2. To ignite, turn Ignition Burner Knob to
Hi.
3. Push and hold electronic ignition button.
4. If ignition does not occur in 5 seconds, turn the burner controls OFF, wait
5 minutes, and repeat the lighting procedure.
5. To ignite other main burners, with any burner already lit, and on Hi, switch any
adjacent burner to Hi and follow step 4.
Manual Ignition: You can light your barbecue manually by holding a lit match
next to one of the burners, then turning the burner control knob to
Hi. You can
access the burner from underneath the barbecue, or from a hole in the side of the
barbecue body.
Side Burner: To ignite the Side Burner, turn side burner knob to Hi,
follow steps 3 & 4.
If You Have Difficulty Lighting
If the burner doesn't light first go, return the knob to the OFF position and try a couple more times. If the burner still
does not light, return the knob to OFF wait a few minutes to allow the gas to disperse before trying again. If satisfactory
operation cannot be achieved, consult your retailer before proceeding.
Note carefully: Failure to follow the lighting procedures correctly can lead to a hazardous condition.
Control The Flames
The knobs have three basic position: OFF, Hi and Low.
You can achieve any flame height between Low and Hi
by rotating the barbecue control knob between these positions.
Checking The Flame
Look underneath the barbecue so that you can see the flames. They should be a soft blue color with yellow tips. If the
flames are too yellow, there is too much gas and not enough air. The flame will be inefficient and will give off too much
smoke. If the flame is too pale, there is too much air and not enough gas. If either of these situations occur, you will
need to adjust the burners.
23
Advertisement
Table of Contents
