Error Messages - Panasonic KX-TG1062 Operating Instructions Manual

Error messages

If the unit detects a problem, one of the following messages is shown on the display.
Display message
Busy
Check tel line
Error!!
Failed
Incomplete
Memory full
Messages full
No link. Reconnect base AC
adaptor.
Requires subscription to
Caller ID.
Use rechargeable battery.
For assistance, please visit http://www.panasonic.com/help
Cause/solution
L The called unit is in use.
L Other units are in use and the system is busy. Try again
later.
L The handset you are using is too far from the base unit.
Move closer and try again.
L The handset's registration may have been canceled. Re-
register the handset (page 27).
L The supplied telephone line cord has not been connected
yet or not connected properly. Check the connections
(page 8).
L Recording was too short. Try again.
L Phonebook copy failed (page 19). Confirm the other unit
(the receiver) is in standby mode and try again.
L Phonebook copy is incomplete. The receiver's phonebook
memory is full. Erase the unnecessary phonebook entries
(page 17) from the other unit (the receiver) and try again.
L The phonebook memory is full. Erase unnecessary
entries (page 17).
L Message memory is full. Erase unnecessary messages
(page 32, 33).
L Message memory is full. Erase unnecessary messages
(page 32, 33).
L The handset has lost communication with the base unit.
Move closer to the base unit and try again.
L Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L The handset's registration may have been canceled. Re-
register the handset (page 27).
L You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller ID
service, this message will not be displayed.
L A wrong type of battery such as Alkaline or Manganese
was inserted. Use only the rechargeable Ni-MH batteries
noted on page 4, 5.
Useful Information
41