Installation Instructions - APW Wyott XWAV1417 Installation And Operating Instructions Manual

Electrical ratings:
MODEL
WATTS VOLTS
4100
XWAV1417
4100
XWAV1499 5400
5400
7200
XWAV1829
7200
Power Cord:
Six (6) foot, 3 wire grounded cord. If the supply cord is damaged, the manufacturer, or an authorized
service agent, must replace it in order to avoid a hazard and warranty. Please contact the factory by
calling the 800 # located on the unit.
Shipping Weight:
XWAV1417 98lbs.(44.5kg.);XWAV1422 115lbs. (52.2kg.);XWAV1$29 149 lbs. (67.6 kg.)
If the carton appears damaged, or damage is discovered once the carton is opened, stop
immediately and contact the freight company to file a damage claim.
1. Remove all external packaging that is protecting top portion of unit.
2. Remove unit from snipping container while in the upright position. The unit can be lifted out of the
carton by grasping under the conveyor on each side of the appliance. Please remove the plastic
bag.
3. Remove all internal packaging to the unit. Important: Remove urethane supports located
inside the tunnel oven between the top heaters and the conveyor. Remove tape from
conveyor trays. Remove tape from extrusion corners. Remove tape from deflecting curtains
located just above entrance and exit of conveyor.
4. Visually inspect all external and internal portions of unit for damage. Important: Inspect the
top white ceramic elements located inside the oven tunnel after removal of urethane
supports. To inspect these white ceramic elements, use a small mirror held under each element to
detect cracks. Important: The Ceramic elements are fragile and will break under
stress. Do not twist, pull, push, or otherwise subject the white ceramic elements to
stress.
5. Wipe down the exterior of the unit using a damp cloth with warm water. Do not use abrasive pads or
cleaners as they will damage the stainless steel surface and high temperature plastic.
NOTE: DO NOT USE CLEANERS OF ANY KIND ON THE WHITE CERAMIC HEATERS.
6. Remove four feet from box and install into threaded nuts located at the four corners underside of the
left and right housings; Also remove conveyor extension tray(s). Conveyor extensions should be
hung off end of conveyor frame. As our standard, Model XWAV1417 will only have one extension
intended for the exit end; Model XWAV1422 and XWAV1829 will have two for loading and exit ends.
7. Place unit in operating location.
Note. Ambient Conditions - Make sure that the operating location is in an area where the
ambient temperature is held constant (minimum 70°F). Please avoid areas such as near
exhaust fans and air conditioning ducts.
AMPS (1 Phase)
208 19.7
240 17.1
208 26.0
240 22.5
208 34.6
240 30.0

4. INSTALLATION INSTRUCTIONS

NEMA PLUG
6-30P
6-30P
6-30P
6-30P
6-50P
6-50P