Troubleshooting; Compliance With Fcc Regulations - AT&T PBH20 User Manual

Troubleshooting

Symptom
Music is not
streaming over
Bluetooth
No power
PBH20 does not
answer phone calls
Music does not
resume after ending
a call
Not able to control
music from the
PBH20
Page 10
Solution
Check to make sure
both devices are paired
and connected over
Bluetooth.
Restart the PBH20 to
auto-connect with your
Bluetooth device.
Make sure the PBH20 is
fully charged.
Check to make sure
both devices are paired
and connected over
Bluetooth.
Restart the PBH20 to
auto-connect with your
Bluetooth device.
Press play to resume
music.
Check and make sure
your mobile device
supports Bluetooth
A2DP profile.
Contents

Compliance with FCC Regulations

Caution!
The user is cautioned that changes or modifications not expressly approved
by the party responsible for compliance could void the user's authority to
operate the equipment.
The equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate
Radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to Radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to Radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from which the
receiver is connected.
- Consult the dealer or an experienced Radio/television technician for
assistance.
This equipment complies with FCC's RF radiation exposure limits set forth
for an uncontrolled environment. The antenna(s) used for this transmitter
must be installed and operated to provide a separation distance of at
least 20 cm from all persons and must not be collocated or operating in
conjunction with any other antenna or transmitter. Installers must ensure
that 20 cm separation distance will be maintained between the device
(excluding its handset) and users.
THE SPECIFICATION AND EXTERNAL
HEADPHONES ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE.
If at any time in the future you should need to dispose
of this product, please note that waste electrical
products should not be disposed of with household
waste. Please recycle where facilities exist. Check with
your local authority or retailer for recycling advice.
APPEARANCE OF THE
Page 11